Installation Guide

1. Remove the original power LED​

Remove the original power LED on the GBC by heating the two through hole legs at the back of the board

Untitled-1.png
2. Align the board to the buttons and cut outs.

Add tape where the original LED was to avoid shorts. 

The link cable pins and pin 1 and 32 of the cart may need to be trimmed to allow the board to sit flat. This will not effect gameplay at all.

PXL_20210214_051315104_edited.jpg
3. Solder 5V and GND pad to the board.

Add solder to the pads. Make sure the are lined up with the pins on the board

20210124_194918_2.jpg
4. Reassemble the GBC

When reassembling, make sure that the power LED aligns with the shell cut out for the LED (next to the screen)